CONTROLS, INSTRUMENTS AND EQUIPMENT
fmo2009-004-093_a
TYPICAL
1. Mountain strap
WARNING
This strap is not for towing, lifting
or other purpose than temporary
use as a grab handle when a lever-
age is needed at very low speeds.
14) Adjustable Handlebar
The handlebar height is adjustable. To
adjust, proceed as follows:
1. Pull up the lock lever.
fmo2015-003-006_a
1. Lock lever
2. Bring the handlebar to the desired
position and push down the lock
lever to lock it.
NOTE: On the other models, the steer-
ing can be set to a desired fixed posi-
tion, see your Lynx authorized dealer.
______________
52
15) Tool Kit
A tool kit containing tools for basic
maintenance is supplied with the vehi-
cle.
The tool kit support is located in engine
compartment on pulley guard.
NOTICE
Make sure tool kit is prop-
erly secured to avoid contact with
belt or pulley.
To remove the tool kit support from
the pulley guard, unlock the tab from
underneath the pulley guard and pull
the tool kit support towards front to
release it.
fmo2012-003-008_a
TYPICAL
1. Tool kit
16) Storage Compartment
The storage compartment is located
behind the driver's seat.
WARNING
The storage compartment must
be properly latched and must not
contain any sharp or breakable ob-
jects.
To open the lid, pull and hold the rubber
tab sideways, then lift the RH side of
the lid.