Perform An Analysis Using The Keypad - Micromeritics ACCUPYC II 1345 Operator's Manual

P A
ERFORM AN NALYSIS USING THE
Prerequisites:
Specify analysis and report parameters, and
n
Prepare and load sample
n
1. Press Alt + 4 to display the Sample ID prompt. Enter an appropriate identification. Press
(decimal) to insert a dash.
2. Press ENTER to display the Description prompt.
Most users display this prompt only when a keyboard is attached to the pycnometer.
3. Press ENTER to display the Sample Mass prompt. Enter the sample mass.
4. If an analytical balance is connected to the module, press the appropriate button on the bal-
ance to transfer the sample mass while this prompt is displayed.
5. Press ENTER to display the Chamber Insert prompt if using an insert. Press CHOICE until
the appropriate insert is displayed, then press ENTER.
6. Press ENTER to begin the analysis. Operational status messages display during analysis.
7. When the analysis has finished, the pycnometer beeps three times and the display returns to
the Reload prompt.
Do not remove the cell chamber cap when the pycnometer is pressurized. The sample
may be discharged from the chamber.
8. Ensure the pressure reads approximately 0 (zero), then remove the cell chamber cap and
remove the sample from the chamber.
9. Replace the cell chamber cap or load another sample.
Display Text
Analyze Sample ID:
Analyze
Description Line 1:
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev A) — Jan 2021
K
Description
Enter sample identification for the current analysis. Sample ID can be
up to 20 numbers and dashes. Press . (decimal) to insert a dash.
Enter the description for the current sample. A prompt for Line 2 of the
description is displayed.

Perform an Analysis using the Keypad

EYPAD
.
6 - 5