3D Histech Pannoramic MIDI II 2.0.5 User Manual page 32

Pannoramic MIDI II 2.0.5 User's Guide
To insert or remove a filled tray from the device, first check tray for
incorrectly inserted slides (refer to Figure 9) and always ensure also
when moving the tray, slightly tilt it to its closed side to prevent the
slides from accidentally falling out. Inserts should always be kept clean
from dust, broken glass and other mounting media residues. Slides will
only operate safely and properly, if trays are clean.
2. Attach the FL tray covers on the insert sled.
After the tray is inserted into the device, the FL tray covers must be
attached thus securing the tray movement area from external impacts
and the effectiveness of Fluorescent scanning while slides are digitized.
Do not place objects near the device, or in the movement area of the
slide tray.
3. After digitizing slides, the tray is moved to the output position where it can be removed.
December 7, 2018 – Rev. 1
Caution!
Figure 11 – FL tray cover
Warning!
Caution!
3DHISTECH Ltd.
3.2 Inserting and Removing Slides
32(144)