3D Histech Pannoramic MIDI II 2.0.5 User Manual page 31

Pannoramic MIDI II 2.0.5 User's Guide
Incorrect slide insertion may break the glass. Always make sure that
slides are correctly inserted in the tray. The edge of the broken area of
the slide is sharp and its removal can lead to injury and contagion!
Broken slide can be removed only by a well-trained person!
Only original 3DHISTECH trays are allowed for use with Pannoramic
MIDI II!
The coverslip and the label area should be on the top.
To insert and remove trays
1. Insert the tray (2) that contains at least one slide into the opening (1) on the right side of
the device. Push it until it cannot be pushed further and the LED switches from green to red.
December 7, 2018 – Rev. 1
Caution!
Note:
Figure 10 – Inserting the tray
3DHISTECH Ltd.
3.2 Inserting and Removing Slides
31(144)