Transporting Pannoramic Midi Ii - 3D Histech Pannoramic MIDI II 2.0.5 User Manual

Pannoramic MIDI II 2.0.5 User's Guide
5. Hold the filter module by its handling pads (5) (one on the right, one on the left side of the
module) and insert its upper part in forward tilted position under the upper spring-loaded
clamps (1).
6. Press the filter module by its handling pads, until it safely connects to the bottom spring-
loaded clamps (6).
7. Mounting position of the filters: Excitation filter (4); Emission filter (3).
8. To remove the filter module, first slightly tilt it out of its bottom spring-loaded fixtures (6),
then pull it out of the upper spring-loaded components (1) and take it off.
9. Place the protective covers back again (see section 7.3.1 Opening the protective covers).
10. If a Lumencor SOLA SM II illumination unit is used, turn it on again (consider the cooling time
possibly required).

7.3.4 Transporting Pannoramic MIDI II

The following procedure shows how to transport Pannoramic MIDI II in-house. For transporting the
whole system to other location, see Appendix.
The base unit does not have carrying handles for transporting. Two
people can carry the base unit by holding it by its base plate. You can
find the weight data of the base unit in section 8. Technical Data.
Be sure that the scan camera is not moved during transportation.
To transport Pannoramic MIDI II do the following:
1. Turn power supply off and detach all cables.
2. Remove the slide tray if necessary.
3. Transport Pannoramic MIDI II with the help of another person.
4. After finishing transportation, reestablish cable connections.
December 7, 2018 - Rev. 1
Note:
Caution!
3DHISTECH Ltd.
7 Troubleshooting and Maintenance
132(144)