Focus Tool - Trotec Speedy 360 flexx Operating Manual

Operation
7.7.1

Focus tool

Notice
Using a flexx lens the focus point differs depending on the laser source.
70
1. Move the processing head over the material to be
engraved by means of the Laser head control button X/
Y (2) on the keypad.
1
2
2. Hang the focus tool (3) on the allocated space on the
laser head so that the focus tool can move unhindered.
3. Move the X-axis downwards by pressing the Working
table control button Z (1).
4. Before the focus tool reaches the workpiece, move the
working table upwards very slowly and step by step by
briefly tapping the working table control button Z (1)
until the focus tool tilts to the side or falls off its position.
Now the lens is focused onto the surface of the
material.