Coupling The Rotating Brushes/Pads - HAKO Scrubmaster B400 R Operating Manual

Maintenance and servicing
5.6.4

Coupling the rotating brushes/pads

Attention
In the case of rotating brushes that have been in use, there is a pre-
tilt of the bristles (tufts of bristles are deformed and stand at an
angle). It is important not to mix up the rotating brushes. The rotating
brushes must be placed under the respective holder where they
were before.
1
Fig. 52
1 Soft key Couple rotating brushes
2 Start process Couple rotating brushes
3 Process progress
4 Process Couple rotating brushes completed
1. Make sure that the rotating brush unit has been raised and the machine is
stationary.
2. If present, unlock the two side collision protection systems Fig. 49-3 on
both sides of the machine, raise them slightly and swivel them to the side.
3. Raise both side wipers Fig. 49-4 on both sides of the machine and swivel
them to the side.
4. Place the rotating brushes/pads in a central position underneath the rotat-
ing brush unit holder. Then move another centimetre in the driving direction
of the machine.
5. Select the soft key Couple brushes Fig. 52-1 using the turn-push knob and
confirm.
The action window Fig. 52-2 opens.
6. Use the turn-push knob to confirm the start.
The process starts and the multifunction display shows the following
symbols one after the other Fig. 52-3, 4. Only now has the process been
completed.
7. Check whether the rotating brushes have been coupled. Also pay attention
to unusual noises or vibrations.
8. Swivel back both side wipers and hook them in.
9. If present, swivel back the two side collision protection systems and hook
them in.
134
2 3 4
Scrubmaster B400 R (7190)