Operation
3.4.4
Handling and braking the vehicle
Danger
Danger of tilting over when driving on excessively steep slopes
Transport on slopes of up to 10 % (standard drive) or 18 % (X-AC
drive) must only take place for a limited period of time and with
special caution.
Drive slowly on wet surfaces, particularly in bends, due to the risk
of skidding.
When driving uphill, downhill or across slopes, avoid sudden turns
and drive slowly into the bend.
Note
Set the key switch to 0 to immediately disable all the functions.
Observe the following points when driving:
Adapt the driving speed to the ambient conditions, the local conditions and
the load condition of the machine.
Driving speed and braking of the machine are controlled via the accelerator
pedal.
The engine brake is automatically applied when the accelerator pedal is
released. This also applies when ascending or descending.
Stop the machine: Release the accelerator pedal. Press the brake button
for maximum deceleration.
When the machine is at standstill, the parking brake is activated automati-
cally. It is no longer possible to push the machine.
Overload protection
In case of an overload, e.g. excessively steep slopes, the drive motor is
switched off after a certain period of time.
Let the machine cool down for approx. 15 minutes.
Restart the machine.
88
Scrubmaster B400 R (7190)