Cleaning The Rotating Brushes; Decoupling The Rotating Brushes/Pads - HAKO Scrubmaster B400 R Operating Manual

1. Decouple the rotating brushes/pads, see section 5.6.3.
2. Couple new rotating brushes/pads, see section 5.6.4.
5.6.2

Cleaning the rotating brushes

Check and clean the rotating brushes Fig. 50-4 in the rotating brush unit
Fig. 50-1 as required but at least once a day.
1. Decouple the rotating brushes, see section 5.6.3.
2. Clean the rotating brushes thoroughly under running water, solid parts must
be removed.
3. Couple the rotating brushes, see section 5.6.4.
5.6.3

Decoupling the rotating brushes/pads

1
Fig. 51
1 Soft key Decouple rotating brushes
2 Start process Decouple rotating brushes
3 Process progress
4 Process Decouple rotating brushes completed
1. Make sure that the rotating brush unit has been raised and the machine is
stationary.
2. Select the soft key Decouple the brushes Fig. 51-1 using the turn-push
knob and confirm.
The action window Fig. 51-2 opens.
3. Use the turn-push knob to confirm the start.
The process starts and the multifunction display shows the following sym-
bols one after the other Fig. 51-3, 4.
Only now has the process been completed.
4. If present, unlock the two side collision protection systems Fig. 49-3 on
both sides of the machine, raise them slightly and swivel them to the side.
5. Raise both side wipers Fig. 49-4 on both sides of the machine and swivel
them to the side.
6. Remove the rotating brushes/pads.
Scrubmaster B400 R (7190)
2 3
Maintenance and servicing
4
133