Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
PROBLEM
DISC GANG PLUGGING
DISC GANG WILL NOT TURN OR
PUSHES SOIL
DISC BLADES LOOSE AND/OR
SHEARING ROLL PIN
WINGS FLOATING/BOUNCING IN FIELD
5-2
PROBABLE CAUSE
Operating depth too deep
Conditions too wet
Depth set too deep for loose or wet
conditions
Gang bearing failure
Gang not tightened properly
Wing latch not hooked
SOLUTION
Raise unit.
Wait until conditions more favorable.
Raise implement or wait until conditions
are more favorable.
Replace bearing
Retighten gang shafts to 1200-1500 ft-lbs.
If gangs have ran loose, gangs may
require disassembly to remove soil to
properly torque gang shafts. Replace
any worn components, shafts/spools,
etc.
Fully extended fold cylinder and be sure
3/4-10 x 3 hex head cap screw in the
top of the hook is free to rotate. .
F-571-0511 Edition
Advertisement
Table of Contents
