Resetting The Printer - Datamax M-Class Mark II Operator's Manual

5 . 8 R e s e t t i n g
5 . 8 R e s e t t i n g
5 . 8 R e s e t t i n g
Depending upon the method used, there are three reset levels possible:
Soft Reset - To reset the printer and clear any temporary host settings:
1. With the printer 'On', press and hold the
four seconds.
Level One Reset - To return the printer to the factory default settings or, if saved, to restore
the Factory Setting File:
1. Turn 'Off' the printer.
2. Turn on the printer, when the three lights turn on press and hold the PAUSE and CANCEL
Keys; continue to depress the keys until the 'READY' message or Ready light appears.

This reset has the same effect as the System Settings / Set Factory Defaults selection
in the menu system.
Level Two Reset - To return the printer to the firmware default settings, and clear all the
calibration and adjustment parameters:
1. Turn 'Off' the printer.
2. Turn on the printer, when the three lights turn on press and hold the PAUSE, FEED, and
CANCEL Keys; continue to depress the keys until the 'READY' message or Ready light
appears.

After executing a Level 2 Reset, the media calibration must be performed; see Section
3.5.
Chapter 5 – Maintenance and Adjustments
t h e P r i n t e r
t h e P r i n t e r
t h e P r i n t e r
PAUSE and CANCEL buttons for approximately
54