Datamax M-Class Mark II Operator's Manual page 72

Displayed Message





Chapter 6 – Troubleshooting
Printer Fault Messages (continued)
Description
The printer could not find
the TOF mark within the
maximum label length
setting or it found a TOF in
an unexpected place.
When the printer is set

for reflective media, this
fault is given for an out of
stock condition.
Possible Solution(s)
If media is moving:
1) Press the FEED Key. It may be
necessary to re-calibrate the printer;
see Section 3.5.
2) The Media Sensor may be out of
position. Readjust it; see Section 2.3.
3) The media may not be properly loaded.
Reload media, also ensure that the
Media Guide is positioned properly; see
Section 2.2.
4) The Media Width Adjustment may be
improperly adjusted; see Section 5.3.
5) The label may be longer than the default
value for maximum length. Check the
Media Settings / Maximum Label Length;
see Section 4.5.
6) The Media Sensor may be obstructed.
Check and carefully remove any
obstruction (labels, paper dust,
adhesive, etc).
If media is not moving:
The printhead assembly may not be latched.
66