Datamax M-Class Mark II Operator's Manual page 92

C . 3 C a l i b r a t i o
C . 3 C a l i b r a t i o
C . 3 C a l i b r a t i o
In 'Calibration' mode, the buttons allow the printer to adjust to the media being used. Calibration
can be performed either automatically or manually, as detailed below.
Before calibrating, ensure that the Printhead Carrier Assembly is latched down, that the cover
is closed, and that the media sensor has been set for the appropriate media type.

Printer and cutter faults are disabled during
can still occur while printing "test" labels.
If at any time you wish to discard your changes and revert back to the previous calibration
simply turn off power to the printer.
To perform Calibration:
CANCEL
Calibration Mode
Auto Media Calibration
Media Sensor Calibration
Appendix C – Paper Menu Setup
n M o d e – B u t t
n M o d e – B u t t
n M o d e – B u t t
(Press and hold during power-up until the
PAUSE
( Press and
FEED
Release
(
Press and
FEED
Hold
CANCEL
Prints the 'Test Label' for "test"
PAUSE
Saves the current values
+
and resumes
CANCEL
PAUSE
Analyze for 'Paper'
FEED
Analyze for 'Backing or 'Mark'
CANCEL
Analyze 'Out of Media' condition
PAUSE
Accepts the current
+
values for "test"
CANCEL
o n F u n c t i o n s
o n F u n c t i o n s
o n F u n c t i o n s
and
)
Feeds one label for "test"
(Until Paused light turns off)
)
Normal Mode
STOP
light turns off)
DONE
, but
86