Media Sensor Adjustment - Datamax M-Class Mark II Operator's Manual

2 . 3 M e d i a S e n
2 . 3 M e d i a S e
2 . 3 M e d i a S e
The Media Sensor needs to be positioned so that the printer can detect the presence of media and
the top-of-form (except for continuous stock, where the TOF is set through the front panel.
To adjust:
1. With media loaded, as described in Section 2.2, grasp the Slide Tab and move the Sensor
Eye Mark into position over media according to the table below.
2. If loading media, return to the media loading instructions.
Media Sensor Selection and Adjustment
Media Type
Die-cut
Notched
Reflective
Continuous
Chapter 2 - Printer Setup
s o r A d j u s t m e
n s o r A d j u s t m e
n s o r A d j u s t m
Sensor Eye Mark Position
Near the middle of the label
Centered over the notch
Centered over the black mark
Near the middle of the media
n t
n t
e n t
Sensing Required
Gap
Gap
Reflective
Continuous

'Sensor Eye' Mark

Slide Tab
8