Resetting The Printer; Warm Reset; Factory Default Reset - Datamax S-Class ST-3210 Operator's Manual

3.6 Resetting the Printer

There are two different reset levels possible for the printer:
3.6.1

Warm Reset

To reset the printer and return to the on-line mode: Press the PAUSE
button to go off-line and then press the F1 + F3 buttons simultaneously.
3.6.2

Factory Default Reset

To return the printer to default database settings (see the table below),
perform the following procedure.
ΠTurn the printer 'Off'.
• Press and hold the PAUSE/F1, FEED/F2 and TEST/F3 buttons while
turning 'On' the printer.
Ž After the Fault Indicator flashes (approximately 20 seconds), release
all three buttons.
For verification, a Configuration Ticket can be printed. The printout will
reflect default settings until new configuration data is sent to the printer.
Function
Memory Configuration:
Internal Module
Scalable Fonts
Character Set:
(DPL parser mode only)
Cutter
[2]
Parser Mode:
[3]
Print Speed:
[3]
Slew Speed:
Backup Speed:
Stock ID
Print Width
[1]
Memory allocations are represented in 4KB units each and modifiable only when in the
DPL parser mode.
[2]
The parser mode setting may arrive factory-configured to meet your application;
otherwise see Section 4.3.1.
[3]
All speed values given in Inches Per Second.
20
Default Database Settings
ST/SV 3210 Values ST/SV 3306 Values
[1]
[3]
1.89 inches (48 mm) 1.92 inches (49 mm)
128
64
Standard
Auto Detect
DTPL
8
8
3
5
ST/SV-3210 and ST/SV-3306
128
64
Standard
Auto Detect
DTPL
4
4
3
5