Resetting The Printer; Warm Reset; Factory Default Reset - Datamax ST-3210 Operator's Manual

3.5 Resetting the Printer

There are two different reset levels possible for the printer:
3.6.1

Warm Reset

To reset the printer and return to the on-line mode: Press the PAUSE
button to go off-line and then press the F1 + F3 Buttons simultaneously.
3.6.2

Factory Default Reset

To return the printer to default database settings (see the table below),
perform the following procedure.
Turn the printer 'Off'.
Press and hold the PAUSE/F1, FEED/F2 and TEST/F3 Buttons
while turning 'On' the printer.
After the Fault Indicator flashes (approximately 20 seconds), release
all three buttons.
For verification, a Configuration Ticket can be printed. The printout will
reflect default settings until new configuration data is sent to the printer.
Function
Memory Configuration:
Internal Module
Scalable Fonts
Character Set
(parser mode dependent):
Cutter
2
Parser Mode:
3
Print Speed:
3
Slew Speed:
Backup Speed:
Stock ID
Print Width
1
Allocations are in 4KB units each and configurable only in DPL Parser Mode.
2
This setting may arrive pre-configured, to change the setting see Section 4.3.1.
3
Values given are in Inches Per Second.
S-Class
Default Database Settings
ST/SV 3210 Values
1
3
1.89 inches (48 mm)
128
64
See Appendix B
Auto Detect
DTPL
8
8
3
5
ST/SV 3306 Values
128
64
See Appendix B
Auto Detect
DTPL
4
6
3
5
1.92 inches (49 mm)
25