Datamax M-Class Mark II Operator's Manual page 50

STX-V SW
SETTINGS
ENABLED
DISABLED
MAX LENGTH
COMMAND
ENABLED
DISABLED
OPTION
FEEDBACK
DISABLED
SCANNER
RFID HEX
RFID ASCII
PROCESS SOH
(DATA)
ENABLED
DISABLED
Chapter 4 – Menu System
Determines the way in which the DPL <STX>V command is handled, where:
Processes commands normally. (Default Setting)
Ignores the option-enable command; instead, the option selections are controlled
via menu settings.
Determines the way in which the DPL <STX>M command is handled, where:
Processes commands normally. (Default Setting)
Ignores the maximum label length command; instead, Maximum Label Length is
controlled via the menu setting.
Allows feedback characters from an optional device to be returned to the host
device, in the format of: <A;B;C;D;E;F>[CR]
Where:
A - Is the device type: R = RFID; and, S = Linear Scanner
Is the resulting status: C = entire label complete; F = faulted (failed)
B -
label; and, U = unknown
C - Is the number of expected reads, given in two characters.
D - Is the number of good reads, given in two characters.
E - Is the internal Job and Sub Job Identifier, given in four characters each.
F - Is the data that was read, delimited with semicolons (;) on multiple reads.
No data is reported. (Default Setting)
Linear Scanner information is reported.
RFID information is reported in hexadecimal format.
RFID information is reported in an ASCII format.
Determines the way the printer responds to an Immediate Command (e.g., Get
Status, Module Storage, etc.), where:
Operations are interrupted upon receipt to process the command.
Processes commands normally. (Default Setting)
44