Datamax M-class Mark II Manual
Hide thumbs
Also See for M-class Mark II:
- Operator's manual (100 pages) ,
- Maintenance manual (94 pages) ,
- Manual (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Datamax M-class Mark II
Summary of Contents for Datamax M-class Mark II
- Page 1 92-2491-01 Rev.B Media Hubs...
-
Page 3: Tools Required
Overview This document describes the contents and installation of the Media Hub options for the M-Class MII printer. Only qualified service personnel should perform this installation. After verifying the kit contents and the tools needed, follow the steps below to install the option. Contents The contents of the Media Hub Kit differ according to kit number: (3-Inch Media Hub Kit) contains the following items:... -
Page 4: Installation
Installation Only qualified service personnel should perform this installation. Always wear a wrist strap and follow standard ESD prevention measures when handling any printer CAUTION circuit card assembly. A) Turn OFF the Power Switch and unplug the power cord from the AC Receptacle. Power Switch Disconnect the interface AC Receptacle... - Page 5 Main Logic Card D) Disconnect the cables from the Main Logic Card. Card Cage Screws E) Remove the Screws that secure the Main Logic Card and the Fill Plate to the Card Cage. Remove the Fill Plate then slide the Main Logic Card out of the printer.
- Page 6 Main Logic Card G) Slide the Main Logic Card into the Card Cage and replace the Fill Plate. Secure the Main Logic Card and the Fill Plate using the previously removed Screws. Reconnect all the cables to the Main Logic Card. Power Supply Screws H) Remove the Ground Strap...
- Page 7 Power Supply Screws J) Install the Power Supply then place the Line Filter Bracket onto the Line Filter. Line Filter Bracket Screws Secure the Power Supply using the Power Supply Screws and the Line Filter Screws. Line Filter Power Supply Line Filter Bracket K) Insert the Ground Strap...
- Page 8 Cover Screws M) Tighten the Cover Screws on the Centerplate. Centerplate N) Connect the interface cable(s). Plug the power cord into the AC Receptacle and turn ON the Power Switch. Power Switch This completes the installation process; refer to AC Receptacle the Operator’s Manual for media loading instructions.