Touchpanel Mounting; Touchpanel Removal - Crestron Isys i/O TPMC-15-CH-L Operation Manual

Touchpanel Media Centers
50 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series
Crestron Isys i/O
If the BB-15L/BB-17L or PMK-15L/PMK-17L are to be used and a touchpanel is
not available, the installer can either leave the hole in the mounting surface open (if
permitted by local building codes) or attach the cover plate supplied with the
mounting kit.

Touchpanel Mounting

Required Tools
#2 Phillips tip screwdriver
1. If the cover plate is attached, use a #2 Phillips screwdriver to loosen and
remove the four screws and plate.
2. Connect all required cables to the touchpanel.
3. Insert the touchpanel (without its bezel) into the mounting option and align
the eight screw holes.
4. Insert and tighten the eight supplied screws (finger tight and then using a #2
Phillips screwdriver, tighten an additional 1/8-turn).
5. Cover the mounted unit with the bezel. Refer to the illustration after this
step for guidance.
Exploded View for Mounting the TPMC-15-QM-L in the Optional BB-15L Back Box

Touchpanel Removal

If it is necessary to remove the touchpanel after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #2 Phillips tip screwdriver.
1. Lift the bezel off the touchpanel. Do not apply excessive pressure to the
touchscreen.
™
TPMC-15/17-L Series
Operations Guide - DOC. 6354