Crestron Isys i/O TPMC-15-CH-L Operation Manual page 34

Touchpanel Media Centers
30 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series
Crestron Isys i/O
NOTE: The touchpanel's calibration routine can also be accessed through Crestron
Toolbox if the touchpanel is connected to a control system via Cresnet and/or
TCP/IP or to a PC via RS-232 by selecting the device from the Network Device Tree
and right-clicking the device to select Functions | Setup Mode.... Select Enter
Calibration Mode to begin calibration.
Press OK to accept the changes and return to the SETUP MENU.
Display Output (QM-L Versions Only)
Pressing Display Output shows the output resolution of the touchpanel and provides
test charts for adjusting skew, peak, and boost settings on a remote display.
"Display Output" Window
Select the following Test Patterns, in the following order, and adjust the display as
necessary.
1. Vertical Lines
2. Grid
3. Color Bars
4. Grayscale Gradient
5. Frequency Adjust Test
6. Streak Test
7. Skew Test
8. RGB Gradient
Select Project
Permits the selection of the touchpanel program, a .vtz file. The default file location
is the internal flash. To select a project from the internal flash, select Browse and
select the compiled project to be loaded.
If loading an external file, check External as the Project Working Path and use the
Select button to select the network drive and/or flash drive where the compiled
™
TPMC-15/17-L Series
Operations Guide - DOC. 6354