Crestron Isys i/O TPMC-15-CH-L Operation Manual page 20

Touchpanel Media Centers
16 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series
Crestron Isys i/O
functionality/compatibility will be available in future firmware releases.
USB Type A Connector Pinout
PIN DESCRIPTION
1 +5 VDC
2 Data -
3 Data +
4 Ground
NOTE: Only standard Windows
load your own driver.
NOTE: The maximum length for a USB cable run is 16.4 feet (5.0 meters)
PWR
This female connector is used to supply 12.5 VDC power to the touchpanel from the
included external power pack (Crestron part number PW-1280RU) or the included
TPMC-L-IMC. For more information, refer to "Hardware Hookup" on page 47.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
PWR OUT
This female power connector is used to supply 12.5VDC power to the touchpanel
from the TPMC-L-IMC using the included nine inch power cable. For more
information, refer to "Hardware Hookup" on page 47.
PWR IN
Connect these two connectors to the power output of the TPMC-L-IMC. For more
information, refer to "Hardware Hookup" on page 47.
PHONE
Connect this standard mini phone jack (105 mW per channel, 8 ohm load) to the plug
of an external headphone set, not supplied.
PC CARD
Two Type II PCMCIA Card slots used for memory expansion up to 4GB or more or
VT Pro-e project uploads. A cover is secured over the slots to protect the electronics.
Use a #1 Phillips screwdriver to remove the cover. The plate can be flipped and
secured if only one slot needs to be accessed.
CAUTION: PCMCIA cards should be installed with the label facing the screen.
™
TPMC-15/17-L Series
Pins 1 2 3
®
XP embedded drivers are included. You cannot
Operations Guide - DOC. 6354
4