Crestron Isys i/O TPMC-15-CH-L Operation Manual page 62

Touchpanel Media Centers
58 • Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17-L Series
3. Enter a new IP address, IP Mask, Default Router, or select Enable DHCP
and click OK.
4. Ensure that all devices are connected to the control processor. For TCP/IP,
use CAT5 straight through cables with 8-pin RJ-45 connectors to connect
the LAN port on the touchpanel and the LAN port on the PC to the Ethernet
hub. Alternatively, you can use a CAT5 crossover cable to connect the two
LAN ports directly, without using a hub. The following figure illustrates
pinouts for straight through and crossover RJ-45 cables. Pins 4, 5, 7, and 8
are not used.
RJ-45 Straight Through Cable – For Connection Through Hub
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
RJ-45 Crossover Cable – For Direct PC Connection
FROM COLOR
PIN
1 White/Orange
2 Orange
3 White/Green
6 Green
5. Once the cable connections are made, open Crestron Toolbox and click
Tools | Manage Address book to display the "Address Book" window.
6. Click Add Entry and type a name for the new device.
7. Click TCP as the connection type. Enter the IP address or hostname of the
touchpanel and click OK.
"Address Book" Window – TCP/IP Setup
™
Crestron Isys i/O
SIGNAL TO PIN
Tx+ 1
Tx- 2
Rc+ 3
Rc- 6
SIGNAL TO PIN
Rc+ 3
Rc- 6
Tx+ 1
Tx- 2
TPMC-15/17-L Series
SIGNAL
Tx+
Tx-
Rc+
Rc-
SIGNAL
Tx+
Tx-
Rc+
Rc-
Operations Guide - DOC. 6354