Touchpanel Mounting - Crestron TPS-2000L Operation Manual

5 Inch Lectern/Wall Mount Touchpanel
14 • 5 Inch Lectern/Wall Mount Touchpanel: TPS-2000L
Mounting Options for the TPS-2000L
PRE-CONSTRUCTION
OPTION
Back Box Kit
Pre-Construction Mount Kit
Mud Mount Kit (accessory)
Trim Mount Kit (accessory)
-
-
-
* Pre-construction refers to framed walls prior to hanging drywall.
** Post-construction refers to framed walls with drywall hung.
If the BB-2000L or PMK-2000L are to be used and a touchpanel is not available, the
installer can either leave the hole in the mounting surface open (if permitted by local
building codes) or attach the cover plate supplied with the mounting kit.

Touchpanel Mounting

Required Tools
#1 Phillips tip screwdriver
1. If the cover plate is attached, use a #1 Phillips screwdriver to loosen and
remove the four screws and plate.
2. Connect all required cables to the touchpanel.
3. Insert the touchpanel (without its faceplate) into the mounting option and
align the four screw holes.
4. Insert and tighten the four supplied screws (finger tight and then using a #1
Phillips screwdriver, tighten an additional 1/8-turn).
5. Insert the ten buttons. If the buttons are engraved, verify that the placement
of the each button matches the programming.
6. Cover the mounted unit with the faceplate. Refer to the illustration after this
paragraph for guidance.
Crestron Isys
*
POST-CONSTRUCTION
OPTION
-
-
-
-
Wall Mount Kit - Mud
Wall Mount Kit - Trim
Water Resistant Cover
Operations Guide – DOC. 5972A

TPS-2000L
**
MODEL DOCUMENT
NUMBER NUMBER
BB-2000L 5973
PMK-2000L 6018
MMK-2000L 6025
TMK-2000L 6026
WMKM-2000L 6025
WMKT-2000L 6026
TPS-WPK 5993