Beginning Configuration - Mircom TX3 Series Installation Manual

•
•
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel.
The Network Firmware Upgrade procedure can update more than one panel at
the same time. In order to use the Network Firmware Upgrade, all of the panels
must already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be
found on the TX3 Configurator Software installation CD, the USB flash drive, or
on the Mircom website.
4.13.1 Firmware Version Control
The firmware version number is accessible from the Configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
4.14

Beginning Configuration

The card access controller is now configurable using the following connections.
•
•
•
•
For a complete description of the configuration and on how establish a
connection to the card access controller using a USB, Ethernet, COM port or
modem connection, see the following documentation:
•
•
UL Listed TX3-CX Card Access System Installation Manual
Version 2
LT-6906 Copyright 2019
Firmware Upgrade Wizard
Network Firmware Upgrade
USB connection
Ethernet connection
COM port connection
Modem connection
LT-995 Configuration and Administration Guide
LT-973 TX3 Configurator Quick Start
Setup of the Card Access Controller
57