Figure 30 Controller Board Card Reader Connectors - Mircom TX3 Series Installation Manual

4.9.2 Card Reader Connection
BEEPER
Figure 30. Controller board card reader connectors
Connect the readers to the terminals shown in figure 30.
Table 2:
Card readers supplied by Mircom require a foil shielded multiple conductor
stranded cable, at least 22 AWG. For example, use Belden 9535 or a similar
cable.
The black wire can be connected to either COM (−) connector on the terminal
block.
UL Listed TX3-CX Card Access System Installation Manual
Version 2
LT-6906 Copyright 2019
Card Reader A
COM(−)
RED LED PWR+
GRN LED
DATA0
Connections for the TX3-P300-HA and TX3-P500-HA readers
Color
Blue
Orange
Brown
Red
Green
White
Black
Setup of the Card Access Controller
Card Reader B
BEEPER
DATA1
COM(−) RED LED
GRN LED
Terminal
BEEPER
RED LED
GRN LED
PWR+
DATA0
DATA1
COM(−)
COM(−) DATA1
PWR+
COM(−)
DATA0
53