Mircom TX3 Series Installation Manual page 58

Verify the following:
•
•
•
•
To start the configuration
1.
2.
3.
UL Listed TX3-CX Card Access System Installation Manual
58
LT-6906 Copyright 2019
Ensure that the controller and all connected devices and components are
fully operational.
Ensure the controller DIP Switches (SW2) are set with a unique network
address.
Ensure the Configurator software is set with the correct controller network
address.
Ensure that your PC and the Configurator are set with the correct date and
time.
Connect the PC to the controller using the USB port.
Launch the Configurator and click Connect. Once connected the
connection icon appears in the Configurator tool bar.
Configure the Card Access System using the instructions in the
Configurator Software Program or the LT-995 Configuration and
Administration Guide.
Setup of the Card Access Controller
Version 2