Firmware Version Control; Beginning Configuration - Mircom TX3 Series Installation And Operation Manual

3.10.1

Firmware Version Control

3.11

Beginning Configuration

Version 2.2
LT-980
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be found
on the TX3 Configurator Software installation CD, the USB flash drive, or on the
Mircom website.
The firmware version number is accessible from the configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
The Card Access Controller is now configurable using the following
connections.
• USB connection
• Ethernet connection
• COM port connection
• Modem connection
For a complete description of the configuration and on how establish a
connection to the Card Access Controller using a USB, ethernet, COM port or
modem connection, see the following documentation:
• LT-995 Configuration and Administration Guide
• TX3 Configurator Quick Start LT-973
Verify the following:
• Ensure that the controller and all connected devices and components are
fully operational.
• Ensure the controller DIP Switches (SW2) are set with a unique network
address.
TX3-CX Card Access System Installation and Operation Manual
Copyright 2015
Installation and Setup
53 (61)