Unit Power-Up - Weco Cruiser Power Pulse Instruction Manual

Cruiser 322/402/502T
Power Pulse 322/402/502T
CODE SYMBOL
S3
S4
S5
S6
E1
4

UNIT POWER-UP

Set the welding power source ON/OFF switch to "I" to switch on the unit.
FX.X The message appears on the following display: D2.
x.x= software version
First power-up or power-ups following a RESET procedure
The welding power source sets up for welding with the factory pre-sets.
Subsequent power-ups
The welding power source sets up for welding in the latest stable welding configuration that was active
at the time of power-off.
WELD TH E W O R L D
DESCRIPTION
Press and release: the button opens the JOBs upload menu.
Hold down for 3 seconds: the button opens the JOBs save and delete menu.
Press and release: the button enables the device to receive the welding current control signal
from a remote controller.
Hold down for 3 seconds: the button activates a connected remote controller, if available, which
is then used to manage all functions of the welding power source from a distance.
TIG DC / TIG AC mode: This button selects the torch trigger procedure.
MMA mode: Press the button to show the selected electrode type for MMA welding.
This button selects the welding mode.
Data setting: The encoder sets the value of the selected parameter.
Welding: The encoder sets the value of the following parameter: WELDING CURRENT
Cod. 006.0001.1680
09/06/2020 V.2.10
ENGLISH
13