Leveling The Rear Squeegee - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean

Leveling the Rear Squeegee

Leveling the squeegee assembly provides a uniform fl are of
the squeegee blade. It is important that this adjustment be
performed on an even, level surface.
1. Lower the squeegee.
2. Drive the machine forward approximately 2 ft (0,6 m).
3. Set the parking brake.
4. Examined the curl in the squeegee rubber around the
entire back edge of the squeegee blade.
If the fl air is not even across the rear squeegee blade
proceed with the following:
5. Locate the two sets of adjustment nuts on the two
squeegee adjustment rods.
Note: Raising the rear bumper and then lowering the
squeegee will provide greater access to the adjusting nuts.
6. To lower the front of the squeegee turn the two
adjustment nuts on each adjustment rod rearward (away
from the front of the machine).
To lower the rear of the squeegee turn the two
adjustment nuts on each adjustment rod forward (toward
the front of the machine).
Page 80
7. Lock the adjustment nuts.
8. If necessary proceed to Adjusting the Rear Squeegee
Blade Flare.
9. Test the squeegee for water pick up.
10. Re-adjust to level the squeegee if necessary.
ADJUSTMENT NUTS
FOR SQUEEGEE
ADJUSTMENT RODS
Fig. 2: Leveling the Rear Squeegee
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.
FLAIR TO BE EVEN