Operating Procedures; Pre-Operation Checks; Starting - HAKO PowerBoss Nautilus User Manual

OPERATING PROCEDURES

PRE-OPERATION CHECKS

Prior to starting the engine, check the following:
1. Engine oil level is within the operating range -- indicated
with small holes on the engine oil dipstick.
2. Engine coolant level is within the operating range --
indicated within "full" and "low" on the overfl ow bottle.
3. Fuel level. For LP powered machines, confi rm the LP
tank is turnd on. To turn the valve ON, turn the valve
counter clockwise until it stops. The valve is located
on the LP tank.
4. Hydraulic fl uid level is within the operating range --
indicated fl uid level within the sight gauge.
5. Brakes, steering, and directional controls.
6. Signs of fl uid leaks on and under the machine.
7. Condition of scrubbing brushes. Remove any strings
and debris wrapped around them.
Fluid levels should be within the correct amounts to opperate
the machine.
Brakes, steering and directional controls should be
functioning properly.
Hoses, lines and tanks should be free of damage and leaks.
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.

STARTING

WARNING
Before starting the engine, sit in the operator's seat
and make sure the parking brake is engaged.
1. Make sure the directional control pedal is in the neutral
position. LP engines: Confi rm the LP tank valve is on.
2. Engage the parking brake.
3. Make sure the throttle is in the idle position.
4. LP and Gasoline-powered: Turn the ignition key to
the start position (clockwise). When the engine starts,
release the key.
Diesel-powered: Turn the ignition key
to the "on" position (do not try to start).
Press down and hold the Glow Plug
Switch for 10-12 seconds, release the
switch. Turn the ignition key to the start
position (clockwise). When the engine
starts, release the key.
CAUTION
If the engine fails to start, do not continue cranking
for more than ten seconds. Allow the starter motor to
cool between attempts.
PowerBoss
®
The Power of Clean
GLOW
PLUG
SWITCH
Page 41