Turning Or Replacing The Rear Squeegee Blades - HAKO PowerBoss Nautilus User Manual

Turning or Replacing the Rear Squeegee Blades

Check the squeegee blades daily for wear or damage.
After the squeegee edge wears half-way through the
thickness of the squeegee blade the squeegee blade can be
turned over so that a new edge will be against the cleaning
surface.
After the second edge wears the squeegee blade can be
turned end-to end to use the third edge, and fi nally turned
over once again to use the fourth edge.
Replace any damaged squeegee blade.
Note: The rear squeegee blade can be accessed with the
rear bumper raised or closed. With the rear bumper raised
the outer squeegee can be turned or replaced without
removing the squeegee tool from the machine. Servicing the
inner squeegee is best done with the squeegee tool removed
from the machine.
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.
1. Ensure that the rear squeegee is raised up off of the fl oor.
2. Shut off the engine and set the parking brake.
For Safety: Before leaving machine, turn off the machine,
set the parking brake, and remove the key.
3. Raise the rear bumper.
4. Loosen the two squeegee retaining knobs. (See Fig. 1)
5. Pull the lower end of the squeegee hose from the
squeegee tool. (See Fig. 1)
6. Lift the squeegee tool off of the squeegee frame
SQUEEGEE
RETAINING KNOBS
Fig. 1: Turning/Replacing the Rear Squeegee Blades
PowerBoss
®
The Power of Clean
SQUEEGEE
HOSE
Page 81