Adjusting The Scrub Brush Pattern (Equal Width) - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean

Adjusting the Scrub Brush Pattern (Equal width)

The width of the two scrub brush patterns should be equal.
If they are not equal the level of the scrub deck must be
adjusted front-to-back. (See Fig. 3)
1. Open the two side doors and raise the seat mount.
2. Lengthen or shorten the leveling rods located on each
side of the machine above the scrub deck. Lengthening
the rods will increase the front scrub brush pattern width.
(See Fig. 4)
3. Adjust the leveling rods in equal amounts.
4. Check the scrub brush pattern again and readjust if
necessary.
Fig. 3: Brush Pattern (width not equal)
Page 76
Fig. 4: Leveling Rod location
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.
LEVELING
ROD