Driving; Slowing And Stopping; Inclines Or Slippery Surfaces; Stop The Machine - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean

DRIVING

The direction control pedal moves the machine forward
and backward. To move the machine forward or backward,
fi rst release the parking brake.
• To move Forward: Apply pressure to the front of
the directional control pedal, increasing pressure to
increase speed.
• To move Backwards: Apply pressure to the rear of
the directional control pedal, increasing pressure to
increase speed.

SLOWING AND STOPPING

Allow the directional control pedal to move into neutral.
Step on the brake pedal.

INCLINES OR SLIPPERY SURFACES

Always travel slowly when operating on inclines or slippery
surfaces.
WARNING
Do not travel across or turn on inclines, to maintain
stability of the machine.
Always travel straight up or down on inclines.
Page 42

STOP THE MACHINE

1. Stop scrubbing and drive the machine forward until the
rear squeegee raises.
2. Stop the vehicle using the foot brake.
3. Push the engine throttle switch to idle.
4. Turn off the ignition key switch to the off position.
5. Remove the key.
6. Set the parking brake.
7. On LP powered machines turn the LP tank service
valve OFF. To turn valve OFF, turn the valve clockwise
until it stops. The valve is located on the LP tank. (See
Fig. 1)
LP TANK
SERVICE
VALVE
Fig. 1: LP tank, service area
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.