Emptying/Cleaning The Debris Hopper - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean
EMPTYING/CLEANING THE DEBRIS
HOPPER
Note: The debris hopper must be emptied and cleaned
daily.
1. Drive the machine to an appropriate dump site. Shut off
the engine and set the parking brake.
2. Swing the orange bumper lever arm out from under the
rear bumper. (See Fig. 1)
3. Release the rear bumper latch located under the right
side of the rear frame while lifting up on the bumper
lever arm. (See Fig. 1)
4. Raise the bumper up until the safety arm locks into
place. (See Fig. 1)
Note: The orange safety arm is located on the driver side
of the rear bumper assembly. Ensure that the lower end of
the safety arm is securely locked into place over the mating
bar on the frame.
5. Locate the orange hopper handle under the right rear
corner of the machine and pull the hopper cradle back
and down onto the fl oor. (See Fig. 1)
Page 38
BUMPER
LEVER
Fig. 1
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
BUMPER
SAFETY
ARM
LOCK
BUMPER
HOPPER
HANDLE
© 2014-2015 Minuteman International, Inc.
REAR
LATCH