Adjusting The Rear Squeegee Blade Flare - HAKO PowerBoss Nautilus User Manual

Adjusting the Rear Squeegee Blade Flare

Be sure that the squeegee assembly is adjusted to level
before performing the fl are adjustment. It is important that
this adjustment be performed on an even, level surface.
Note: Raising the squeegee casters increases the
squeegee fl are, lowering the casters reduces the squeegee
fl are.
1. Lower the squeegee.
2. Press and hold the idle button located under the key
switch.
3. While holding the idle button turn off the engine key
switch Set the parking brake.
4. Lift the squeegee assembly up by hand and allow it to
rest back down on the fl oor. The squeegee blade should
be standing straight up on the fl oor with no fl air.
5. Loosen the locking knobs on the squeegee casters.
6. Adjust the casters until they clear the fl oor by .25 in
(0,63 cm). Use a .25 in (0,63 cm) thick spacer for this
procedure.
7. Check the squeegee fl are (See Checking the Rear
Squeegee Blade Flare).
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.
8. Test the squeegee for water pick up.
9. Make fi ne adjustments to the caster height for optimum
water pick up on the fl oor surface to be cleaned.
Fig. 1: Adjusting the Rear Squeegee Blade Flair
PowerBoss
®
The Power of Clean
SQUEEGEE
CASTER
LOCKING
KNOB
Page 79