Stop Scrubbing - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean
5. Press the bottom of the green one-touch button to begin
scrubbing.
6. When double scrubbing use the maximum solution fl ow
setting and a high brush pressure.
7. Make a pass over the area to be scrubbed. This will
dispenses solution over the area allowing the detergent
to soak on the fl oor. Let the solution remain on the fl oor
for 5 - 10 minutes, then make a second pass with the
squeegee lowered (squeegee switch in the "on" position).
Use caution when double scrubbing in areas where cleaning
solution may run under storage racks or damage product.
Note: When fi nished double scrubbing, unlock the side
squeegee blades and reposition the side brush squeegee
blade to its original height.
Page 34

STOP SCRUBBING

1. Press the top of the green one touch button to stop
scrubbing. The scrub brushes will shut off and raise, and
the solution fl ow will shut off . After a few seconds the
squeegee will raise and a few seconds later the vacuum
fan will shut off .
2. Continue driving the machine forward until the squeegee
raises.
3. If the engine throttle switch is set to the idle position the
engine will automatically return to idle after the vacuum
fan shuts off .
4. When fi nished set the controls back to the normal
scrubbing position.
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.