Spray And Vacuum Wand - HAKO PowerBoss Nautilus User Manual

PowerBoss
®
The Power of Clean

SPRAY AND VACUUM WAND

The spray wand option is used to clean areas that are
otherwise inaccessible.
1. Park the machine close to the area to be cleaned.
2. Lower the squeegee and shut off the engine.
3. Set the parking brake.
4. Remove the hose from the top of the rear squeegee.
5. Remove the spray wand tubes from the retainer clips and
assemble the wand.
6. Remove the vacuum hose from the hose rack and attach
the small end of the hose to the upper end of the wand
and the large end of the hose to the machine squeegee
hose.
7. Attach the wand solution hose to the quick disconnect
fi tting on the upper end of the wand and to the quick
disconnect fi tting located on the rear bumper of the
machine between the tank drain hoses. (See Fig. 1)
8. Start the engine.
9. Position the throttle switch to the "fast" position.
10. Lower the squeegee to turn on the vacuum system.
Page 46
REAR BUMPER
QUICK CONNECT
Fig. 1: Spray Wand Quick Disconnect
Nautilus Rider Scrubber/Sweeper #988749UM Rev. K 04/21
© 2014-2015 Minuteman International, Inc.