General Safety Instructions; Operating Safety Instructions - HAKO Scrubmaster B5 Operating Manual

Safety instructions
1.2

General safety instructions

Note
Before starting up the machine, read the following safety instructions
and act accordingly. Machine operating errors can be avoided and
trouble-free operation can be guaranteed only with precise factual
knowledge.
• Before starting up the machine, please carefully read the operating manual
you receive as well as further separate instructions for additional imple-
ments or attachments and observe them in all aspects of your work.
• The machine may be used, maintained and repaired only by persons who
have been instructed by Hako experts.
• The machine is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or by persons lacking the
required experience and knowledge.
• The operating manual should always be available at the machine's place of
use and should therefore be stored with the machine.
The short instructions do not replace this operating manual and are only to
be understood as instructions for use.
• Please hand over these documents to the new owner/operator on sale or
rental of the device. Have the hand-over confirmed!
• The labels attached to the machine provide important information for safe
operation. Renew labels that are no longer legible or present.
• With Hako-AntiBac® machine variants, the plastic inner surface of the
solution and waste water tanks contains silver ions in nanoparticle form.
• Spare parts must be original spare parts to guarantee safety.
1.3

Operating safety instructions

Before putting into service
• Before initially starting up the machine, charge the used battery fully and
appropriately with commissioning charge. Please observe the operating
manual of the charger and the operating manual of the battery manufac-
turer, which are enclosed with each Li-Ion battery. Hako assumes no
liability for battery damage resulting from insufficient commissioning
charge.
• Check the machine for operating safety before every start-up! Eliminate
faults immediately.
• Before starting work, the operator must familiarise themselves with all the
equipment, controls and actuating elements as well as with their function!
8
01-7150-00.fm