General Provisions; Operating Information - HAKO Scrubmaster B100R Instruction Manual

Safety information
1.2

General Provisions

• Apart from the provisions contained
in this instruction manual, the gener-
al safety provisions and the accident
prevention regulations as imposed
by law have to be complied with.
• Before taking your machine into op-
eration, carefully read the instruction
manual as well as other separate in-
structions for accessories or at-
tached implements and comply with
all points mentioned there during
work.
• Persons being trained by qualified
Hako technicians only are autho-
rised to operate, service and repair
the machine.
• This vehicle is not intended to be
used by persons (including children)
with limited physical or mental capa-
bilities or persons without sufficient
experience and ability.
• You are advised to thoroughly study
the safety instructions since precise
knowledge only helps avoiding er-
rors during operation of the machine
and thus guarantee faultless usage
of the machine.
• The operating instructions have to
be at hand at the place of use of the
6
machine, and therefore have to be
kept readily available at the ma-
chine.
• When selling or letting the machine
for rent, hand out these documents
to the new owner/operator and have
the transfer certified!
• The warning and instruction plates
attached to the machine contain
valuable advice about safe opera-
tion. Immediately replace incomplete
or illegible labels.
• As far as safety standards are con-
cerned, spare have to equal genuine
spare parts!
1.3

Operating information

• Before starting up the vehicle, check
that the vehicle is safe for operation
and all the components are installed.
• In the event of faults, shut the vehicle
down, lock it to prevent it being used
further, place a sign on it indicating
"Defective, do not put into opera-
tion". Clear the cause of the fault as
quickly as possible, only then can
the vehicle be started up again.
• Before starting work, the operator
must be fully familiar with all adjust-
ment, operating and control ele-
ments as well as their respective
function!
• Always wear heavy duty, non-slip
footwear when working with the vehi-
cle.
• The vehicle may only be driven and
the equipment used on those surfac-
es which have been approved by the
contractor or person appointed by
him.
• Only use cleaning agents suitable for
the vendor (non-foaming) and ob-
serve all the use, disposal and warn-
ing information provided by the
cleaning agent manufacturer.
• Only open empty recovery tanks. –
Risk of tipping.
• Before starting with wet cleaning, the
area in question should have been
swept clean.
• When transporting the vehicle, the
squeegee and brush head must be
raised. – Risk of damage.
• The way of driving must be adapted
to the local conditions. When driving
the vehicle, pay attention to persons,
particularly children.
• On finishing work, remove the igni-
tion key to prevent the vehicle being
used without authorization.