Table of Contents
Advertisement
■Definition and terminology
Term
A
Accumulated flow
Accumulated pulse output
Accumulated-value hold time
B
Bottom value display (mode)
C
Chattering
D
Delay time
Digital filter
Display accuracy
Display color
Display value fine adjustment
(function)
E
Error displayed
Error output
The total amount of fluid that has passed through the device. If an
instantaneous flow of 100 L/min lasts for 5 minutes, the accumulated flow will
be 5 x 100 = 500 L.
A type of output where a pulse is generated every time a predefined
accumulated flow passes. It is possible to calculate the total accumulated flow
by counting the pulses.
A function to store the cumulative flow value in the product's internal memory
at certain time intervals. Reads the memory data when power is supplied.
Accumulation of data begins with the value read at the moment power is
supplied. The time interval for memorizing can be selected from 2 or 5
minutes.
Shows the minimum from when the power was supplied to the current time.
The problem of the switch output turning ON and OFF repeatedly around the
set value at high frequency due to the effect of pulsation.
The setting time from when the measured value reaches the set value, to
when the ON-OFF output operates.
Delay time setting can prevent the output from chattering.
The response time indicates when the set value is 90% in relation to the step
input.
Function to add digital filtering to the fluctuation of measured value. Smooth
the fluctuation of displayed value for sharp start up or fall of the flow and
pressure.
When the function is valid, digital filtering is reflected to the ON/OFF of the
switch output. The response time indicates when the set value is 90% in
relation to the step input.
Output chattering or flicker in the measurement mode display can be reduced
by setting the digital filter.
Indicates the maximum deviation between the displayed pressure value and
the true value.
Indicates the color of the number of digital display. Always green, always red,
green (switch OFF) red (switch ON), red (switch OFF) green (switch ON)
are available.
Displayed pressure value can be adjusted within the range of 5%R.D. (5%
of displayed value). It is used if the true pressure value is known, or to
eliminate differences between the displayed values of different instruments
that are measuring the same pressure.
The code number displayed, identifying the error detected by the
self-diagnosis function of the flow switch.
Refer to the "Error display" on page
Switches the switch output to ON/OFF when an error is displayed.
Refer to "Switch output modes" on page
Refer to the "Error display" on page
-15-
Definition
93
for details of the errors.
37
for operating conditions.
93
for details of the errors.
No.PF※※-OMY0005
Advertisement
Table of Contents
