7 Servicing
RPK-FSR(H)M - Wall mounted
7.7.9 Removing heat exchanger
!
D A N G E R
TURN OFF all power source switches.
!
C A U T I O N
•
Recover the refrigerant from the unit before the work. After all the refrigerant is recovered, turn OFF all power source switches.
•
Make sure that the unit will not be damaged. If having difficulty in performing the work alone, the work shall be taken by two people.
•
Take special care not to be injured by the heat exchanger fins.
For RPK-(0.4-1.5)FSR(H)M
1 Remove the power source wiring, the transmission wiring and the wiring for the remote control switch.
2 Push the portion indicated by "PUSH" on the underside of the unit to release the catches at the lower part of the unit.
3 Remove the flare nuts attached to the rear piping of the heat exchanger to disconnect the pipings. Then lift the indoor
unit up and draw it frontward to remove it.
4
Remove the front panel according to the "7.7.2 Removal of the front
5
Remove the electrical box according to the "7.7.7 Removing AS
6
Remove the drain pan according to the "7.7.8 Removing drain
Catch for bottom side of indoor unit
"PUSH"
253
SMGB0137 rev.0 - 05/2021
panel" chapter.
motor" chapter.
pan" chapter.
Mounting
plate
Piping holder
Rear piping of heat exchanger
Rear side of indoor unit
Connected
pipings
7