Hitachi RCI-1.0FSR Service Manual page 61

3 Electrical and control settings
Unit electrical wiring and connection
Terminal board connections
DIP switch location
Switch cover
PCB2
Test runs
!
C A U T I O N
• Be careful during the test runs, as some of the safety functions remain disabled: the units operate for two hours without switching off
via the thermostat. The three-minute compressor protection is not enabled during the test.
• Secure the rubber bushes to the panel using adhesive when the outdoor unit ducts are not used.
• The compressor remains at a standstill during forced stoppage.
51 SMGB0137 rev.0 - 05/2021
Electrical
box cover
Switch
cover
Electrical box
cover
Wire for receiver kit or wired remote control
Screw for earth wiring
connection
A 1 2
Fix the wires
by cord clamp
DSW5
RSW1
DSW6
RSW2
DSW9 DSW2
DSW3
Terminal board for
power source
Terminal board
for remote control
switch cable and
transmission wire
3