Removal Of The Electronic Expansion Valve Coil - Hitachi RCI-1.0FSR Service Manual

7 Servicing
RCD-(0.8-6.0)FSR - 2-way cassette

7.3.10 Removal of the electronic expansion valve coil

1 Remove the optional air panel in line with the instructions given
in chapter "7.2.4 Removal of the optional air
2 Remove the bell-mouth and the fan runner as indicated in
chapter "7.2.5 Removal of the fan runner and the fan
3 Remove the evaporator partition plate securing the heat
exchanger by removing the five screws.
4 Remove the electronic expansion valve butyl sheet.
5 Remove the expansion valve coil by firmly pushing it.
?
N O T E
The coil has a fixation system which comprises a protrusion at the
Expansion valve that has to match with the orifices located at the coil.
(See the picture beside), called alignment notch.
6 Once replaced, fit the electronic expansion valve in the reverse
manner as indicated for the removal process.
7 Position the butyl sheet, attaching it correctly to the valve.
?
N O T E
Check that the cables do not touch the fan duct after installation is
complete.
209 SMGB0137 rev.0 - 05/2021
panel".
motor".
Electronic expansion
Expansion
valve coil
Expansion
valve
Electronic
expansion valve coil
(4)
Yellow
valve body
(6)
(5)
Blue
Orange
Electronic expansion
valve connector
Alignment
notch
(1)
Red
(3)
White
(2)
Free
7