Removing Optional Air Panel - Hitachi RCI-1.0FSR Service Manual

7 Servicing
RCI-(1.0-6.0)FSR - 4-way cassette

7.1.3 Removing optional air panel

1 Open the air inlet grille. Remove the connector (CN36) at the air panel from the connector for auto louver (CN17) on
the indoor unit PCB1.
2 Remove the air inlet grille from the air panel.
3 Remove 4 corner pocket covers from the air panel. They can be removed pulling " A " part toward the arrow direction
in the figure below.
* T o attach the corner pocket covers again, insert the fixing hooks ( 1 and 2 ) to the air panel and insert the fixing
hook ( 3 ) to the air panel.
4 Remove 4 long screws from the air panel. Remove them with attention to temporally hook hinges of air panel (2
positions) onto hooks of unit (2 positions). Then, remove the air panel after unhooking 2 hinges from the 2 hooks.
Hook Hook
2
183 SMGB0137 rev.0 - 05/2021
Unit
Unit
Air Panel Air panel
Hinge Hinge
Corner pocket cover Corner Pocket Cover
A
1
3
HITACHI AIR( / )CONDITIONER Model
N112
D
K
Connector for auto louver (CN17)
Indoor unit PCB1
Electrical box
Long screw Long Screw
(4 pcs.)
(4 pcs.)
C-shaped hinge
CN36
C-shaped Hinge
(2 Portions)
(2 positions)
7