Removal Of The Printed Circuit Board (Pcb) - Hitachi RCI-1.0FSR Service Manual

7 Servicing
RCD-(0.8-6.0)FSR - 2-way cassette

7.3.5 Removal of the printed circuit board (PCB)

1 Remove the electrical box cover according to the item "7.1.2 Removing electrical box
2 Disconnect all wire connectors from the indoor unit PCB.
3 Remove the screw for earth wire.
4 Remove the screw then remove the PCB cover.
5 The indoor unit PCB is fixed by holders (6 holders for PCB, 4 holders for fan control PCB). Pinch the holder with long-
nose pliers and pull out PCB from the holders.
!
C A U T I O N
• Do not touch the electrical components of the PCB.
• Do not apply force to the PCB, as this could damage it.
• The sealed earthing cable and the transformer are secured by a screw. When installing, be particularly careful not to overtighten the
set screw.
• Make sure that all connectors are properly connected. Otherwise the Indoor unit PCB maybe be damaged.
(Only RCD-(4.0-6.0)FSR
206 SMGB0137 rev.0 - 05/2021
Holder
Holder
Fan control PCB
cover".
Holder
PCB
PCB
Holder
Holder
Screw for
earth cable
Electrical box
(All models)