Hitachi RCI-1.0FSR Service Manual page 162

5 Optional functions
Optional functions through Remote control
Item Optional function
Detection level of
k5
the motion sensor kit
Selection of allowed
operation modes
when the control
k6
sensor of the indoor
unit is set by C8
function
Not used
k7
Control for the
prevention of
k8
condensation on the
louvres
Not used
kg
Not used
kA
Not used
L1
Not used
L2
152 SMGB0137 rev.0 - 05/2021
Individual
Settings
Setting
00 Standard (factory setting)
01 High
○
02 Low
00 All modes allowed
01 Only cooling/dry allowed
○
02 Only heating allowed
03 All modes allowed
00
01
○ -
02
03
Function disabled
00
(factory setting)
○
01 Function enabled
00
- -
01
00
- -
01
00
01
○ -
02
03
00
01
- -
02
03
Setting conditions
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions.
This parameter defines the
sensitiveness of the motion sensor.
The amount of activity in the room
is assessed according to a different
scale based on this setting.
Detailed information about the
operation of the motion sensor
can be found in the technical
documentation of the indoor units.
This function is used to select the
operation modes in which the setting
of C8 (use of remote control switch
sensor or remote sensor on THM4 to
control the indoor unit) is enabled.
Use at 00 conditions
Condensation may occur around air
outlet during COOL/DRY operation
with horizontal air flow or downward
air flow for long periods.
This function is used to prevent
condensation by moving the
louvre swing angle to the third step
automatically for 30 minutes every
1 hour.
(In RPK units, this function is
activated by means of DSW2-4
instead of the K8 optional function)
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Use at 00 conditions
Description