Removal Of The Automatic Louver Motor - Hitachi RCI-1.0FSR Service Manual

7 Servicing
RCIM-(0.4-2.5)FSRE - 4-way cassette (compact)

7.2.13 Removal of the automatic louver motor

1 Stop the automatic louver:
a. Press AUTO LOUVER on the remote control while the automatic louver is operating.
b. The crank touches the end of the motor securing plate and the louver returns to position 0.
c. The motor power supply switches off when the louver is at the set position.
d. The louver stops at the set position.
2 Remove the optional air panel in line with the instructions given in chapter "7.2.4 Removal of the optional air
3 Remove the fixing screw for C-cover and remove the C-cover.
4 Remove the fixing screw on the AS motor from the air panel. Then, remove the louver, the louver bearing and the AS
motor.
5 Remove the AS motor, stopper and bearing from the louver.
6 Disconnect the connector for the AS motor. Press the catch to disconnect the connector to avoid breakage.
Screw
Bearing
200 SMGB0137 rev.0 - 05/2021
C-Cover
Louver
Air panel
Louver
Pay attention to the
direction of the stopper.
Stopper
Bearing Connector
AS Motor
Bearing
AS Motor
Stopper
Air inlet side
panel".
Bearing
Air panel