Installing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R750 Installation And Service Manual

4. If installed, remove the air shroud
5. If required, remove the drive
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 96. Removing the rear mounting front PERC module
Next steps
1. Replace the rear mounting front PERC

Installing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air shroud
5. If required, remove the drive
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
2. Slide the rear mounting front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the rear mounting front PERC module.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
or remove the GPU air
backplane.
module.
Safety instructions.
Before working inside your
cover.
or remove the GPU air
backplane.
shroud.
system.
shroud.
Installing and removing system components 93