Installing The Boss S2 Card Carrier Blank; Removing The Boss S2 Module - Dell EMC PowerEdge R750 Installation And Service Manual

Next steps
1. Replace the BOSS S2 card carrier blank

Installing the BOSS S2 card carrier blank

Prerequisites
1. Follow the safety guidelines listed in the
Steps
Align the blank with the BOSS S2 module bay and push it into the bay until it clicks into place.
Figure 184. Installing the BOSS S2 card carrier blank

Removing the BOSS S2 module

The procedure to remove is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
182 Installing and removing system components
or install BOSS S2 card
Safety instructions.
Safety instructions.
Before working inside your
carrier.
system.