Installing The Serial Com Port - Dell EMC PowerEdge R750 Installation And Service Manual

Figure 170. Removing the Serial COM port
5. Install the filler bracket if not replacing the serial COM port.
Next steps
1. Replace the serial COM

Installing the serial COM port

The procedure to install serial COM port from Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud
NOTE: The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the serial COM port into the expansion card riser and close the latch.
port.
Safety instructions.
Before working inside your
or remove the GPU air shroud.
system.
Installing and removing system components 171